Electric heating double cone vacuum dryer is a new generation of drying equipment developed by our company in combination with similar domestic products. The specially designed tooling fully reflects the good concentricity of the two shafts. The vacuum system uses a reliable mechanical seal, and the power supply system uses a rotating slip ring of American technology. Based on this, we developed the SZG-C type. The heating medium is heated by a special electric heating plate compound liner. It can adjust the power and can control the heating of the electric heating plate by shunt control to achieve the uniform drying effect of the materials in the tank. This C-type double cone vacuum dryer is particularly suitable for the drying of new energy sources and metal powders, and solves the shortcomings of past years when using heat-conducting oil for heating to produce grease and not rise in temperature. The improved equipment has simple operation, convenient maintenance and long service life.
Suitable for the concentration, mixing, drying and low temperature drying of powdery, granular and fibrous materials in the chemical, pharmaceutical, food, metallurgy and other industries (such as biochemical products). It is more suitable for easy oxidation, easy generation, new energy and Metal powder and material are dried.
During heating, automatic constant temperature control is adopted.
The temperature can be between 50-280 ° C.
High thermal efficiency, more than 3 times higher than the general oven.
Indirect heating, the material will not be contaminated and meets the "GMP" requirements.
Equipment maintenance is simple and easy to clean.
The drying kettle of the dryer rotates, and the transmission adopts gear transmission to ensure the mechanical strength.
Accurate temperature control, the temperature can automatically adjust the electric heating power according to the specific set temperature, equipped with 0-20mA current.
An electric heating device is passed into the sealed sandwich, and the heat is transferred to the dried material through the inner shell; under the drive of power, the tank is slowly rotated, and the materials in the tank are continuously mixed to achieve the purpose of intensified drying; the material is in a vacuum state The concept is that by controlling the temperature, the water (solvent) on the surface of the material reaches the saturated state and evaporates, and it is discharged and recovered by the vacuum pump in time. The water (solvent) inside the material continuously penetrates, evaporates, and is eliminated from the surface. The three processes are continuously carried out, and the material can be dried in a short time. After the war, inert gas was added and mixed with materials to replace oxygen, so as to achieve the purpose of further drying.